

Switches
Campus and data centre switching designed for predictable performance, visibility and room to grow.
What it is
Switches carry almost every packet in your offices and data centres, so their design decides how the network behaves under load and during failures.
In the campus, access switches connect people, phones, cameras and access points, often powering them over PoE. In the data centre, spine-leaf fabrics connect servers and storage with short, equal paths. We design both, select switches by port speed, density, power and features, and configure them for segmentation, redundancy and telemetry.
01
What you get
Capacity that matches demand
Port speeds and uplinks sized for today’s traffic, with a clear path to higher speeds.
Spine-leaf data centre fabrics
Predictable latency between servers and storage, and growth by adding leaf switches.
Power over Ethernet
PoE budgets planned for access points, cameras, phones and IoT devices.
Segmentation and access control
VLANs, VRFs and port-based access control that keep departments, guests and devices apart.
Telemetry
Streaming data on traffic, errors and buffers that shows problems before users report them.
Redundancy
Dual uplinks, redundant power and switch stacking or multi-chassis designs where a single failure must not stop work.
02
Typical scenarios
- 01
Office and campus refresh
Replacing ageing access and core switches with faster, manageable and PoE-capable models.
- 02
Data centre fabric
A spine-leaf network for virtualisation, storage and replication between sites.
- 03
Storage and AI clusters
High-bandwidth, low-latency networks for storage systems and GPU servers.
- 04
Network segmentation project
Separating users, servers, management and IoT to limit how far an incident can spread.
03
How we work
- 01
Inventory and requirements
We record the existing switches, cabling, traffic and power, and collect requirements for speed, PoE and segmentation.
- 02
Design and selection
We define topology, addressing, VLANs, redundancy and monitoring, and compare suitable models from several vendors.
- 03
Installation and migration
We pre-configure the switches, replace them in planned windows and test failover and performance.
- 04
Operation and support
We monitor the switches, keep software up to date and respond to incidents within the response times agreed in the SLA.
05
Frequently asked questions
Can switches from different vendors work together?
Yes, on standard protocols. We design the network so the parts that must work together use open standards, and document where vendor-specific features are used.
How long does a switch replacement take?
It depends on the number of switches and sites. We pre-configure the equipment and replace it in planned windows to keep disruption low.
Do we need a spine-leaf design in a small data centre?
Not always. For a few racks a simpler design may be enough; we recommend spine-leaf when growth, replication or east-west traffic call for it.
Can you take over support of our existing switches?
Yes. We start with an inventory and a health check, then take over monitoring and maintenance under an SLA.
More in this area
- 01
Industrial IoT networking
Industrial-grade networking bridging IT and OT, with ruggedized capabilities for factory, harsh, and outdoor environments.
- 02
Networking software
Keep your data, workloads, and apps connected, secure, and efficient across your global data center networks.
- 03
Routers and SD-WAN
Secure, high-performance routing and SD-WAN infrastructure enabling resilient, scalable enterprise connectivity across campus, branch, and cloud.
- 04
Wireless and access points
High-performance, secure wireless foundation enabling reliable connectivity and superior application experience across modern environments.
Is your switching ready for the next few years?
Tell us about your offices and data centres, and we will suggest how to refresh or extend the network.
